Washer - Chevrolet Equinox 2012 Owner's Manual

Pull the windshield wiper
lever toward you to spray windshield
washer fluid and activate the wipers.
The wipers will continue until the
lever is released or the maximum
wash time is reached. When the
windshield wiper lever is released,
additional wipes may occur
depending on how long the
windshield washer had been
activated. See
for information on filling
the windshield washer fluid
reservoir.
In freezing weather, do not use
the washer until the windshield is
warmed. Otherwise the washer
fluid can form ice on the
windshield, blocking your vision.
Clear snow and ice from the wiper
blades before using them. If frozen
to the windshield, carefully loosen or
thaw them. Damaged blades should
be replaced. See
Heavy snow or ice can overload the
wiper motor.
If the ignition is turned to LOCK/
OFF while the wipers are on LO, HI,
or INT, they will immediately stop.
If the windshield wiper lever is then
moved to off before the driver door
is opened or within 10 minutes, the
wipers will restart and move to the
base of the windshield.
If the ignition is turned to LOCK/
OFF while the wipers are performing
wipes due to windshield washing,
the wipers continue to run until they
reach the base of the windshield.
The rear wiper controls are on the
end of the windshield wiper lever.
.
Press the upper portion of the
button for continuous rear window
wipes.
The rear wiper turns off when
the button is returned to the middle
position.
Press the lower portion of the button
to set a delay between wipes.
the windshield wiper lever forward
to spray washer fluid on the rear
window. The lever returns to its
starting position when released.
Push