Asus CUC2000-M User Manual page 42

3. HARDWARE SETUP
29) ATX Power Supply Connector (20-pin block ATXPWR)
This connector connects to an ATX power supply. The plug from the power sup-
ply will only insert in one orientation because of the different hole sizes. Find the
proper orientation and push down firmly making sure that the pins are aligned.
IMPORTANT:
on the +5-volt standby lead (+5VSB). You may experience difficulty in power-
ing ON your system if your power supply cannot support the load. For Wake-
On-LAN support, your ATX power supply must supply at least 720mA +5VSB.
CUC2000-M
CUC2000-M ATX Power Connector
30) Power Supply Thermal Sensor Connector (2-pin block JTPWR)
If you have a power supply with thermal monitoring, connect its thermal sensor
cable to this connector.
CUC2000-M
CUC2000-M Thermal Sensor Connector
42
Make sure that your ATX power supply can supply at least 10mA
Power Supply On
ASUS CUC2000-M User's Manual
+3.3 Volts
+3.3 Volts
+3.3 Volts
-12.0 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
+5.0 Volts
Ground
Ground
Ground
Power Good
-5.0 Volts
+5V Standby
+5.0 Volts
+12.0 Volts
+5.0 Volts
JTPWR
Power Supply
Thermal Sensor Connector