Asus CUC2000-M User Manual page 20

3. HARDWARE SETUP
4) USB Device Wake Up (USBJ2/USBPJ2)
These jumpers allow you to disable or enable the USB device power up function
for USB devices connected to your system. These two jumpers must be set in
unison; that is, either both must be set to Disable or both must be set to Enable.
This feature requires an ATX power supply that can supply at least 2A on the
+5VSB lead. The default is set to Disable because not all computers have the
appropriate ATX power supply. Your computer will not power ON if you set
these to Enable and do not have the appropriate ATX power supply. NOTE:
These jumpers must be set in conjunction with Wake On USB Device in 4.5.1
Power Up Control.
NOTE: For suspend to RAM to function, these jumpers must be set to Enable.
Setting
Disable
Enable
CUC2000-M
CUC2000-M USB Device Wake Up
5) Onboard LAN Setting (LAN_EN)
The onboard LAN may be enabled/disabled with this jumper.
Setting
Enable
Disable
CUC2000-M
CUC2000-M Onboard LAN Setting
20
USBJ2/USBPJ2
[1-2] (default)
[2-3]
1
1
LAN_EN
[1-2] (default)
[2-3]
ASUS CUC2000-M User's Manual
USBJ2
1
Disable Enable
(Default)
USBPJ2
1
Disable Enable
(Default)
LAN_EN
1 2 3 1 2 3
Enable Disable
(Default)