File Sharing - Ovislink AirLive WMU-6500FS User Manual

least one WLAN card installed on your computer, and AirLive WMU-6500FS is powered on.
Step 1: Enabling the WLAN card first, and check the Wireless f Connection properties from My Network Places.
Step 2: Select the Wireless Networks icon after entering the "Wireless Network Connection Properties". You will
find the airlive_Storage in the available network list, then select the airlive_Storage, and click Connect button to
connect. Otherwise, if you can't find airlive_Storage, please refresh network list again.
NOTE. The default network name(SSID) of AirLive WMU-6500FS is "airlive".
Step 3: Then go to command prompt mode from Start Menu->Programs-> Accessories. Type "ipconfig" in the
command prompt window and press the "Enter". Then the messages of IP address, Subnet Mask, and Default
Gateway should be found.
Step 4: After you connect to AirLive WMU-6500FS successfully, you can use method 1~3 that have been described in
section 2.2.2 to configure AirLive WMU-6500FS.
WARNING:
We strongly recommended that you enable wireless encryption feature, or
add User Access rules on AirLive WMU-6500FS. Otherwise, everyone can
connect to it wirelessly and access data which is stored in your hard drive.

2.3 File sharing

The AirLive WMU-6500FS can be a shared network hard drive in an existing wireless or wired network environment.
The users in the same network area can read or write data from the device as required. The following various steps
are for users to start using the network hard drive.
AirLive WMU-6500FS User's Manual
16