Connect To Wireless Access Point - Ovislink AirLive WN-360USB User Manual

2.2 Connect to Wireless Access Point

After the driver is correctly installed, it will try to connect to any unencrypted wireless access point
automatically. If you want to connect to a specific wireless access point, or the access point you wish
to connect uses encryption, you have to configure the wireless network card and input required
parameters, to get connected to the wireless access point you wish to connect.
The current status of wireless connection will be displayed by AirLive configuration utility icon:
Wireless connection is established, good signal reception.
Wireless connection is established, normal signal reception.
Wireless connection is established, weak signal reception.
Connection is not established yet.
Wireless network card is not detected.
There are two ways you can configure your wireless network card to connect to wireless access point:
using the AirLive configuration utility and using built-in windows zero configuration utility.
WN-360USB User's Manual 12