Table of Contents
Advertisement
Now you are ready to configure the network settings for network access.
You must use the command line to install the driver as instructed above.
Simply copy and paste EtherWe-1000U.kext to the Extensions folder
will lead to an improper installation as the warning message below:
Now the installation is complete. You can connect the adapter to a network device by an
Ethernet cable:
1. Connect an Ethernet cable to the Ethernet port on the adapter.
2. Connect the other end of the Ethernet cable to your network hub, switch or
router.
The Link LED should light up green to indicate a proper physical connection between the
adapter and the network. If the Link LED doesn't light up, please verify the cable
connections between all the network devices.
AirLive EtherWe‐1000U User's Manual
10
Advertisement
Table of Contents
