Cooktop Use; Cooktop Controls; Sealed Surface Burners - Jenn-Air GAS COOKTOP Use & Care Manual

Cooktop Controls

WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death
or fire.
Electric igniters automatically light the surface burners when
control knobs are turned to HI and will automatically reignite if the
flame is extinguished.
If a cross draft is present, the flame may be affected and some
sparking may occur. This is normal.
Before setting a control knob, place filled cookware on the grate.
Do not operate a burner using empty cookware or without
cookware on the grate.
To Set:
1. Push in and turn knob counterclockwise to HI.
2. Turn knob to anywhere between HI and LO. Use the following
chart as a guide when setting heat levels.
SETTING RECOMMENDED USE
HI
Medium
Between HI and LO
LO
REMEMBER: When cooktop is in use, the entire cooktop
area may become hot.
Power failure
In case of power failure, the surface burners can be lit manually.
Hold a lit match near a burner and turn knob counterclockwise to
HI. After burner lights, turn knob to setting.
IMPORTANT: Burner reignition feature does not work without
power.

COOKTOP USE

Start food cooking.
Bring liquid to a boil.
Hold a rapid boil.
Quickly brown or sear food.
To fry chicken.
Maintain a slow boil.
Fry or sauté foods.
Cook soups, sauces and gravies.
Stew or steam food.
Simmer.
Keep food warm.

Sealed Surface Burners

A. Gas tube opening
B. Burner cap slot (4)
C. Burner cap
D. Burner base
Burner installation:
1. Align the arrow on the burner base with the post on the orifice
holder, then place it onto the orifice holder. This will aid in
aligning the notch in the burner base with the igniter
electrode.
2. Install burner cap onto the burner base by aligning the burner
cap slots (4) with the burner base tabs (4).
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help avoid poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.
Gas tube opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of soil
and do not allow spills, food, cleaning agents or any other
material to enter the gas tube opening. Keep spillovers out of gas
tube by always using a burner cap.
A
B
A. Low flame
B. High flame
Burner ports: Check burner flames occasionally for proper size
and shape as shown above. A good flame is blue in color, not
yellow. Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner ports.
To Clean:
IMPORTANT: Before cleaning, make sure all controls are off and
cooktop is cool. Do not use oven cleaners, bleach or rust
removers.
1. Remove the burner cap from the burner base and clean
according to "General Cleaning" section.
2. Clean the gas tube opening with a damp cloth.
A
B
C
D
E
F
G
H
E. Burner base tab (4)
F. Burner base notch
G. Orifice holder
H. Igniter electrode
5