Download Print this page

CARVIN SX50 Operating Manual page 4

Advertisement

This symbol is intended to alert the user to the
presence of uninsulated "dangerous voltage"
within the product's enclosure that may be
of sufficient magnitude to constitute a risk of
electric shock to persons.
IMPORTANT! FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:
WATER AND MOISTURE: Appliance should not be used near water (near a bathtub, washbowl,
kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be taken so
that objects do not fall and liquids are not spilled into the enclosure through openings.
POWER SOURCES: The appliance should be connected to a power supply only of the type
described in the operating instructions or as marked on the appliance.
GROUNDING OR POLARIZATION: Precautions should be taken so that the grounding or polariza-
tion means of an appliance is not defeated.
POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely
to be walked on or pinched by items placed upon or against them, paying particular attention to
cords at plugs, convenience receptacles, and the point where they exit from the appliance.
SERVICING: The user should not attempt to service the appliance beyond that described in the
operating instructions. All other servicing should be referred to qualified service personnel.
FUSING: If your unit is equipped with a fuse receptacle, replace only with the same type fuse.
Refer to replacement text on the unit for correct fuse type.
SAFETY INSTRUCTIONS (EUROPEAN)
The conductors in the AC power cord are colored in accordance with the following code.
GREEN & YELLOW—Earth
U.K. MAIN PLUG WARNING: A molded main plug that has been cut off from the cord is unsafe.
NEVER UNDER ANY CIRCUMSTANCES SHOULD YOU INSERT A DAMAGED OR CUT
MAIN PLUG INTO A POWER SOCKET.
REPlaCEmENT PaRTS lIST
SX50/100C
SX-aMP COMBO 12" 100w
COMPOnenT
QTY/Bill u/M DeSCriPTiOn
For SX50:
80-03150-50
1 EACH PCB ASSY MAIN SX50 SMT PCB
For SX100:
80-03150-100 1 EACH PCB ASSY MAIN SX100 SMT PCB
Hardware For SX50 & SX100:
03-01200 2 EACH STRAIN RELIEF .625 CHS/.35 CBL
03-21800A 2 EACH MICA INSULATOR TO-218 0.002"
03-44319 1 EACH WASHER NYLON .157IDx.315Dx.197
03-49553 2 EACH TAPE W/ADHSVE 3M .375 X .375
03-60043 1 EACH SIL PAD W/ADHESIVE 9 MIL
03-77704 1 EACH LENS METAL RED THREADED
05-00111 1 EACH CABLE SPKR 24" 16AWG QUICK CON
05-01605 1 EACH PWR AC 16AWG SJT 8' W/125MM ST
05-46020 1 EACH SPADE CONNECT 16AWG BLK 203MM
05-48025 1 EACH SPADE CONNECT 18AWG BLK 254MM
05-64410 1 EACH CABLE RIBBON 24A 4P/ 4" W/HDR
05-68415 1 EACH CABLE RIBBON 24A 8P/ 6" W/HDR
05-68430 1 EACH CABLE RIBBON 24A 8P/12" W/HDR
05-96545 1 EACH SPADE CONNECT 16AWG GRN/YEL 5"
06-09252 11 EACH NUT FOR POT 71-09252C
06-10070 8 EACH MS PPH 6-32X .500 BLACK
06-10174 4 EACH SMS POH #10X 1.25 TYPE A BLACK
06-11120 1 EACH NUT METRIC 12MM KUNMING BLACK
06-11905 4 EACH NUT METRIC 9MM CHROME SHIMWOO
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
BLUE—Neutral
BROWN—Live
LIMITED WARRANTY
Your Carvin product is guaranteed against failure for ONE YEAR unless otherwise stated.
Carvin will service and supply all parts at no charge to the customer providing the unit is under
warranty. Shipping costs are the responsibility of the customer. CARVIN DOES NOT PAY FOR
PARTS OR SERVICING OTHER THAN OUR OWN.
REQUIRED TO VERIFY YOUR WARRANTY. Carvin assumes no responsibility for horn drivers
or speakers damaged by this unit. This warranty does not cover, and no liability is assumed,
for damage due to: natural disasters, accidents, abuse, loss of parts, lack of reasonable care,
incorrect use, or failure to follow instructions. This warranty is in lieu of all other warranties,
expressed or implied. No representative or person is authorized to represent or assume for
Carvin any liability in connection with the sale or servicing of Carvin products. CARVIN SHALL
NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
SERVICE
In the USA please go to www.carvin.com/cs
Outside the USA, contact your dealer or go to http://www.carvinworld.com for your nearest service
center. Include a written description of the problem with serial number and date of purchase.
HELP SECTION
1) AMP WILL NOT TURN ON
Check the power to the amp. Check for tripped circuit breakers, unplugged extension cords or
power-strip switches that may be turned off.
2) SX200/H AMP SHUTS OFF WHILE PLAYING
Check the rear SPK IPM switch to make sure it is set properly. Switch to the 4Ω position if you
are unsure where to set it. If the problem continues, contact our service technicians.
3) NO OUTPUT with POWER light ON
Make sure that your speaker is functioning and not blown. Check input, cables & effects
connected to the effects loop, and extension speaker cables for defects & connections.
a) Also verify the effects loop is working by inserting a 1/4" stereo plug into the return jack and
short the tip and ring. If the amp works by doing this, the effects loop jack is defective.
4) KEEP YOUR AMP LOOKING NEW
Try to keep your amplifier free from dust and moisture. To clean, use a damp cloth to wipe the
controls chassis panel and wipe the vinyl covering. Use a dry cloth to be sure the moisture is
removed.
CAUTION
RISK OF ELECTRIC SHOCK
06-11906 4 EACH WSH METRIC 9MM CHROME SHIMWOO
06-30035 4 EACH WSH FLANGED #10 BLACK OXIDE
06-40070 2 EACH TERMINAL .25"TAB/.156"LUG/.032
06-50030 8 EACH NUT KEP #6-32 BLACK OXIDE
06-50053 4 EACH NUT RETAINER U-TYPE #10 SCREW
07-00105B 11 EACH KNOB SX BLACK W/WHITE NUMBERS
07-00106 1 EACH KNOB SX FEATURE BLACK W/WHITE
10-03150 1 EACH CHASSIS SX50/100C
25-31350 1 EACH SWITCH DPST ROCKER BLACK POWER
76-00001 1 EACH WARRANTY CARD "CARVIN"
77-10000 1 EACH LABEL AMP PROD ID TAG
77-03102 1 EACH LABEL OUTPUT JACKS SX100/50C
77-03204 1 EACH LABEL SERIAL NUMBER SX AMPS
87-10120 1 EACH CABINET ASSY SX100
SX200 COMBO 2x12" & SX200H
COMPOnenT
QTY/Bill u/M DeSCriPTiOn
03-01200 1 EACH STRAIN RELIEF .625 CHS/.35 CBL
03-18190 1 EACH CABLE TIE 4"LX .10"W 7/8 BNDLE
03-21800A 2 EACH MICA INSULATOR TO-218 0.002"
03-44319 1 EACH WASHER NYLON .157IDx.315Dx.197
03-49553 2 EACH TAPE W/ADHSVE 3M .375 X .375
03-52221 1 EACH GROMMET RUBBER .375" DIAMETER
03-60043 1 EACH SIL PAD W/ADHESIVE 9 MIL
A COPY OF THE ORIGINAL INVOICE IS
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL! THIS UNIT
CONTAINS HIGH VOLTAGE INSIDE!

Advertisement

loading

This manual is also suitable for:

Sx100Sx200Sx200h