Your Carvin Professional Series Product is guaranteed against failure for ONE YEAR. SAFETY INSTRUCTIONS (EUROPEAN) Carvin will service the unit and supply all parts at no charge to the customer providing the NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER CORD.
4 , 1kHz, < 0.5% THD 150/150 Watts 300/300 Watts 600/600 Watts sons Carvin is able to offer a substantial 1,200 Watts of power from a two rack unit pack- 2 , 1kHz, < 0.5% THD 600/600 Watts age weighing only 25 pounds.
Parts List For F-Series PC Sub Assemblies PCB REF DESCRIPTION PART # FRONT PANEL FEATURES C239 Capacitor, Electrolytic, 22µF, 160V ..47-22016 PCB REF DESCRIPTION PART # C240 Capacitor, Electrolytic, 10µF, 50V ..47-10051 4558 Op Amp .
Page 7
REPLACEMENT PART GUIDE CAUTION RISK OF ELECTRIC SHOCK 0 dB ROTECT POWER CHANNEL 7. POWER INDICATOR THIS UNIT CONTAINS HIGH VOLTAGE An orange LED unmistakably tells when the amplifier is turned on. (The various front COMPONENTS INSIDE. REFER SERVICING panel indicators were deliberately given different colors so the operator can see the status TO QUALIFIED SERVICE PERSONNEL.
4. Are the Accessory Group switches set properly and level controls raised sufficiently? ever blow, simply let the breaker cool down and press to reset.) 5. Are known good speakers connected properly using known good cables? Carvin’s friendly technical support staff will be happy to assist by calling 800-854-2235.
Page 9
Problem Possible Cause Correction Loud hum coming es (located in the from speakers Accessory Group on INPUTS ACCESSORY GROUP OUTPUTS RMS POWERMAX ® (cont’d) the rear panel) to the – right-most position. Toll Free 1-800-854-2235 PARALLEL INPUTS STEREO MONO No sound out of one Bridge switch not set Make sure the bridge SUB FILTER CH 1...
The preferred method of connecting input signals is with balanced XLR’s (two conductors trocution may occur.) plus a shield wire, such as Carvin’s XLR8). Balanced input signals provide the highest gain and best noise rejection. 1/4” phone jacks are also capable of providing balanced input by using a stereo plug (ring-, tip+ &...
As shown above, standard Speakon speaker cables are wired to pins 1+ and 1-. Pins 2+ and 2- are reserved for use when biamping (as is the case on Carvin TR1503 and TR1801 trapezoidal speaker systems), or bridging (not supported).
BRIDGING THE AMP If the amplifier goes in and out of PROTECT every few seconds, then the problem is most Carvin’s F-Series of amplifiers can be operated in bridged mode if you need a high power likely excessive low frequencies (F1200 only).
INPUT “grounded” simultaneously GROUND LIFT switches such as the ones found in Carvin products are great for curing ground loop problems. A more complicated and expensive way would be to isolate two pieces of equipment from each other with ‘audio isolation’ or ‘line matching’ transformers.
Page 14
This diagram demonstrates the use of a Carvin XC3000 active crossover, F1200 amplifier This illustration shows a Carvin XC3000 active crossover, F1200 amplifier for lows, F600 for for lows, F600 for mids and F300 for the highs. By moving the speaker Biamp switch to the mids and F300 for the highs in BRIDGE MONO mode.