Bios Setup; Managing And Updating Your Bios; Upon First Use Of The Computer System - Asus P3P-1394 User Manual

Ieee-1394 motherboard
Table of Contents

Advertisement

4.1 Managing and Updating Your BIOS

4.1.1 Upon First Use of the Computer System

It is recommended that you save a copy of the original motherboard BIOS along
with a Flash Memory Writer utility (AFLASH.EXE) to a bootable floppy disk in
case you need to reinstall the BIOS later. AFLASH.EXE is a Flash Memory Writer
utility that updates the BIOS by uploading a new BIOS file to the programmable
flash ROM on the motherboard. This file works only in DOS mode. To determine
the BIOS version of your motherboard, check the last four numbers of the code
displayed on the upper left-hand corner of your screen during bootup. A larger num-
ber represents a newer BIOS file.
1. Type FORMAT A:/S at the DOS prompt to create a bootable system floppy
disk. DO NOT copy AUTOEXEC.BAT & CONFIG.SYS to the disk.
2. Type COPY E:\AFLASH\AFLASH.EXE A:\ (assuming E is your CD-ROM
drive) to copy AFLASH.EXE to the just created boot disk.
NOTE: AFLASH works only in DOS mode. It will not work with DOS prompt
in Windows and will not work with certain memory drivers that may be loaded
when you boot from your hard drive. It it recommended that you reboot using a
floppy.
3. Reboot your computer from the floppy disk. NOTE: BIOS setup must specify
"Floppy" as the first item in the boot sequence.
4. In DOS mode, type A:\AFLASH <Enter> to run AFLASH.
IMPORTANT!
If "unknown" is displayed after Flash Memory:, the memory chip is
either not programmable or is not supported by the ACPI BIOS and therefore, cannot be
programmed by the Flash Memory Writer utility.
40

4. BIOS SETUP

ASUS P3B-1394 User's Manual

Advertisement

Table of Contents
loading

Table of Contents