Remove the fan blank.
16.
Install the fan, making sure that the fan clicks into place.
17.
Install the access panel (on page 24).
18.
Do one of the following:
19.
For tower models, return the server to an upright position.
o
For rack models, slide the server back into the rack.
o
Connect each power cord to the server.
20.
Connect each power cord to the power source.
21.
Press the Power On/Standby button.
22.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
Do one of the following:
23.
For tower models, install the bezel.
o
Hardware options installation 52