Getting Started
Setup 1: Getting Ready for the Remote Controller
You generally use the Remote Controller to operate the Navigation System. Before using the
Remote Controller, set the dipswitches and insert the batteries as described in the following sec-
tions.
sSelecting dipswitches
When you remove the battery cover of the Remote Controller, you will see the dipswitches as
shown in the following illustration. You can set each dipswitch using the tip of a ballpoint
pen.
ON
ON
1
2
3
4
OFF
Setting Switch 1
Set Switch 1 depending on the display used.
ON :
This is set if turning this on is recommended for a display used with this unit.
OFF : When the following Pioneer displays are used for navigation display:
AVX-P7000CD, AVX-7000, AVD-W8000, AVD-W6000, AVD-W6010,
AVX-7300, AVX-P7300DVD
Setting Switch 3
Set Switch 3 depending on the audio equipment used:
ON :
When combining with Pioneer AV master unit (AVM-P9000R, AVM-P8000R)
OFF : When combining with Pioneer Head Unit with IP-BUS
When combining with AVM-P7000R
➲
Switches 2 and 4 are not to be used (It does not matter whether it is ON or OFF).
➲
Please set the switches correctly according to the combination of your equipment. Please
make sure that the setting is correct, otherwise the Navigation System will not work prop-
erly.
1
Chapter
15