Do not exhaust the cooker hood through the same heated flue which is used for the gas hob or other kitchen appliances. Thank you for purchasing this Caple cooker hood. Please read the instruction manual carefully before you use the hood, and keep it in a safe place.
Page 3
◆ When cooking, pull up the covering metal board, turn on the cooker hood, and then choose the speed. ◆ When you finish cooking, push down the covering metal board, and turn off the cooker hood. ◆ When you turn on the cooker hood again, the speed of the cooker hood remains the same as last time you used it.
Installation 1. The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the cooking surface for the best effect. See Pic 3. 2. Install the cooker hood between two cupboards. Drill and screw on the side boards of the cupboards (the holes≤2mm).The distance between the head of the screw and the side board should be 5mm, and the distance between the screw and the cooking surface should no less than 1040mm.
Pic 9 Pic 10 Pic 11 Pic 12 Cleaning and Maintenance Change and clean the grease filter: You can remove the grease filters following the instruction of Pic 13 and Pic 14, and clean the filters as below: 1. Put the filter in the water(40℃-50℃), pour in some grease-loosening detergent, soak it for about 2-3 minutes and then clean it with a soft brush.
NOTE: make sure the cooker hood is shut off before cleaning Pic 13 Pic 14 Change the Lamp Remove the panel to change the lamp. See Pic 15. NOTE: Make sure the cooker hood is shut off before you change the lamp. Pic 15...
Page 9
G U A R A N T E E C O N D I T I O N S Caple undertake that if within twelve months of the date of the purchase this built-in appliance or any part thereof that is proved to be defective by reason only of faulty workmanship or materials,...
Need help?
Do you have a question about the 1MINCH7 and is the answer not in the manual?
Questions and answers