System Requirement - AOpen AX4G Pro Manual

A X 4 G P r o
A X 4 G P r o

System Requirement

1. AOZVHDD.EXE 1.30b or later.
2. Delete config.sys and autoexec.bat.
Fresh installation of Windows 98 on a new system
1. Execute "Setup.exe /p j" to install Windows 98
2. After Windows 98's installation is complete, go to the Control Panel > Power Management.
a. Set Power Schemes > Sy
b. Click on "Hibernate" and select "Enable
c. Click on the "Advanced" tab, yo
b mentioned above has been completed; othe
"Apply".
3 . Clean boot into DOS and run AOZVHDD utility.
a. If you assign the whole di
sufficient free space ha
system needs at least 80 MB free space. The utility will locate the space automatically.
b. If you assign an individual partition for
provide unformatted an empty partition.
4. Reboot system.
5. You've already implemented ACPI Suspend to-Hard Drive. Click "Start > Shut Down > Standby" then the screen will go off
stem Standby to "Never".
Hibernate Support"
u'll see "Hibernate" on "Pow
rwise on
sk to your Win 98 system (FAT
s to be reserved in the disk, e.g.
Win 98, please run "
then "Apply".
er Buttons". Note tha t this o
ly "S tandby" an d "Shutdow n" will
16 or FAT 32), please run "aozvhdd /c /file". Please remember
if you have 64 MB DRAM and 16 MB VGA card installed, the
aozvhdd /c /part ition".
88
O n l i n e M a n
O n l i n e M a n
ption will only be seen after step
be shown. Select "Hibernate" and
Of course, the system needs to
u a l
u a l