Instructions For The Installer; Technical Data; Installing The Appliance; Transportation, Unpacking - Electrolux EU 5563 C Instruction Book

Ins
Ins
Model
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption (kWh/day)
(kWh/year)
Energy class, according to EU Standards
Freezing capacity (kg/24h)
Rising time (h)
Rated power (W)
Weight (kg)

Installing the appliance

Transportation, unpacking

The appliance and the interior fitting are protected for
transport.
Remove all packaging and any adhesive tape.
Any remnants of adhesive can be removed using
white spirit.
After transportation the appliance must not be
switched on for 2 hours. This is to allow the
refrigerant to settle.
Cleaning
Clean the accessories and the inside of the appliance
with warm water and bicarbonate of soda (5 ml to
0.5 litres of water). Rinse and dry thoroughly.
Do not use detergents, abrasive powders, highly
perfumed cleaning products, wax polishes or
cleaning products containing bleach or alcohol.

Location

The appliance should be positioned in a well
ventilated, dry room.
Energy use is affected by the ambient temperature.
The appliance should therefore:
12
tr uctions f
tr uctions f
EU 5563 C
50
50
525
520
587
0.56
204
B
7
17
60
25
or the Ins
or the Ins
not be installed next to radiators, cookers or
other sources of heat
only be installed at a location where the ambient
temperature corresponds to the climate
classification, for which the appliance is
designed.
The climate classification can be found on the serial
plate.
The following table shows which ambient
temperature is
classification:
Climate Classification Ambient Temperature
SN
N
ST
Mount the spacers supplied in the plastic bag
of the accessories. Hold the spacer as shown
on the Fig., using fine strokes of hammer put it
in its place.
t aller
t aller
correct for each
+10 to +32 °C
+16 to +32 °C
+18 to +38 °C
climate