Related Manuals for Electrolux EU 5832 I
Summary of Contents for Electrolux EU 5832 I
- Page 1 I N F O INSTALLATION GEBRAUCHSANWEISUNGEN INSTALLATION INSTRUCTION MANUAL GEFRIERSCHRANK EU 5832 I FREEZER EU 5832 I 2222 096-71...
-
Page 2: General Safety
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. -
Page 3: Environment Protection
speed up the thawing process other than those ¥ There are working parts in this product which recommended by the manufacturer. Never use heat up. Always ensure that there is adequate metal objects for cleaning your appliance as it ventilation as a failure to do this will result in may get damaged. -
Page 4: Operation
Control Panel B C D Normal/Super push button Super control light Warning light Pilot light Thermostat knob Operation Warning light (C) Insert the plug into the wall socket. Turn the The temperature alarm light turns on automatically Ç È thermostat knob (E), clockwise, beyond the whenever the temperature within the freezer rises (STOP) position.The pilot light (D) will light up, above a certain value which might endanger... -
Page 5: Storage Of Frozen Food
Storage of frozen food Thawing When first starting-up or after a period out of use, Deep-frozen or frozen food, prior to being used, can before putting the products in the compartment let be thawed in the refrigerator compartment or at the appliance run for at least two hours on the fast room temperature, depending on the time available freeze setting, then turn the thermostat knob to the... -
Page 6: Maintenance
MAINTENANCE Warning Unplug the appliance before carrying out This appliance contains hydrocarbons in its cooling any maintenance operation. unit; maintenance and recharging must therefore only be carried out by authorized technicians. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: remove the plug from the wall socket;... -
Page 7: Customer Service And Spare Parts
CUSTOMER SERVICE AND SPARE PARTS If the appliance is not functioning properly, check opening is not obstructed (see ÒDefrostingÓ that: section). ¥ If your appliance is still not working properly after ¥ the plug is firmly in the wall socket and the mains making the above checks, contact the nearest power switch is on;... -
Page 8: Installation
INSTALLATION Location ATTENTION! It must be possible to disconnect the appliance from The appliance should be installed well away from the mains power supply; the plug must therefore be sources of heat such as radiators, boilers, direct easily accessible after installation. sunlight etc. - Page 9 50 mm Instructions for totally built-in appliances Building-in instructions Dimensions of housing min. Height 720 mm Depth 550 mm Width 560 mm D567 For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction.
- Page 10 Apply the sealing strip pushing it between the refrigerator and the adjacent cabinet. D724 Apply covers (B) on joint cover lugs and into hinge holes. D726 Separate parts A, B, C, D as shown in the figure PR266 Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes.
- Page 11 Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ¿ 2 mm at 8 mm from the outer edge of the door.