j6758bk02.book Page 57 Friday, January 28, 2005 8:02 AM
not fully seated card
fully seated card
4 Secure the card bracket with the screw you removed in step 2.
5 Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can cause
damage to the equipment.
6 If you installed a sound card:
Enter system setup (see page 78), select Audio Controller, and then change the setting
a
to Off.
Connect external audio devices to the sound card's connectors. Do not connect external
b
audio devices to the microphone, speaker/headphone, or line-in connectors on the back
panel.
7 If you installed an add-in network adapter and want to disable the integrated network
adapter:
Enter system setup (see page 78), select Network Controller, and then change the setting
a
to Off.
Connect the network cable to the add-in network adapter's connectors. Do not connect
b
the network cable to the integrated connector on the back panel.
8 Install any drivers required for the card as described in the card documentation.
bracket
within slot
bracket caught
outside of slot
Removing and Installing Parts
57