Remote Battery Replacement - Genie INTELLIG 1000 3024H Operation And Maintenance Manual

CHAIN OR BELT - TENSION ADJUSTMENT
• Observe all safety warning and precautions!
• Disconnect power from opener and disconnect
carriage in rail from bullet before beginning this
task.
Visually inspect the chain or belt every 6 months.
NOTE: Tension adjustments should be made with the
door in the down position and the carriage released.
• At the center of the rail the chain or belt should
not be resting on the rail. See adjustment
illustration on right.
– With the bullet NOT engaged to the carriage,
tighten adjustment nut until chain/belt does
not, at the center of the rail, rest on rail. Do NOT
overtighten.
• Is there rust on chain or frayed edges on belt?
– Contact a trained door system technician for
chain/belt replacement.
• Are there kinks or twists in the chain or belt?
– Contact a trained door system technician for
chain/belt replacement.

REMOTE BATTERY REPLACEMENT

Replace remote battery with a CR 2032 coin cell battery.
1. Open the remote case using a washer or coin that fits
into the slot at the top of the remote.
2. Replace battery.
3. Align components and snap case closed.
©2010 The Genie Company
WARNING
Tighten nut to increase
tension on chain or belt
Adjustment required
Correctly adjusted
BELT
Adjustment required
Correctly adjusted
CHAIN
12/2010
Belt
Belt
Approx. 1/8"
Belt at center of rail
Chain
Chain
Approx. 1/8"
Chain at center of rail
21