DAYTEK PLASMA DISPLAY User Manual page 43

Maintenance and Service
Others
°‹
Problem
Remote controller does not work.
PDP TV makes strange noise.
PDP TV indication lamp is On.
Had forgotten Password of V-Chip
Can not select PC mode when D-sub
cable is connected to the RGB output
of Set-top-box.
This PDP TV is for household use and registered as suitable on electromagnetic waves.
¶U
Therefore, you can use it in every location as well as residential areas.
¶U
Supporting display mode
°‹
¶UIt is optimal screen when the resolution is 640 x 480.
Resolution Horizontal Frequency (KHz) Vertical Frequency (Hz)
640°ø480
720°ø400
800°ø600
1024°ø768
°‹ Considerations in Installation
¶UIf any signal of unsupported resolution is input, the "Out of Range" message appears.
Trouble shooting Tips
Action
1. Check if main power is On.
2. Check that the batteries of the remote controller were
loaded properly.
3. Check to see if any obstacle exists between the PDP
TV and the remote controller and remove it, if any.
4. If the batteries have no power, replace them with two
new batteries.
It is the noise when the mechanism expands or contracts
from to changes to the environment due to factors such
as humidity, temperature, etc. It is not a failure.
The red means the Stand-by power is ON. It will take a
few seconds to turn off as the main power is off.
Press §D , §E , §H , §I,
control in V-Chip function.
D-sub cable must not meet VESA standard. (D-sub No. 10
pin must be grounded) Component Cable can be used if
there is an Component Terminal.(See Page 18)
31.47
37.86
37.50
31.47
35.15
37.88
48.08
46.88
48.36
56.48
60.02
buttons on the Remote
60
72
75
70
56
60
72
75
60
70
75
4 3