Recommended Tools; Parts Identification - Genie 1022 User Manual

RECOMMENDED TOOLS

Safety Glasses
Step ladder

PARTS IDENTIFICATION -

Safety Brochures
Safe-T-Beam ® Source
with wire
(Red LED)
Safe-T-Beam
Source/Sensor Bracket
Pro Rail (Chain) Section
6
3/16" Drill Bit
Drill
Ratchet
Phillips screwdriver
Not Shown Full Size .
Safe-T-Beam ® Sensor
with wire
(Green LED)
®
Door Arm
Pro Rail (Belt) Section
PN# 3642036534, 02/26/2010 REV. 1
FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM
Pencil
Tape measure
ARRANGING BOX CONTENTS FOR ASSEMBLY
ORGANISATION DU CONTENU DE LA BOÎTE POUR LE MONTAGE
DISPOSICIÓN DEL CONTENIDO DE LA BOLSA PARA EL MONTAJE
Remove internal boxes.
Enlever les boîtes internes.
Quite las cajas internas.
Remove lens Box and motor power head.
Enlever la boîte des lentilles et la tête motorisée.
Quite la caja de la lente y el motor de la caja de control.
Carefully remove third rail (with chain
attached) and place on floor.
Enlever soigneusement le troisième rail (avec la
chaîne attachée) et le placer sur le sol.
Cuidadosamente quite el tercer riel (con la
cadena acoplada) y ponga en el piso.
Arrange three small boxes for easy access.
Arranger les trois petites boîtes de manière à pou-
voir y accéder facilement.
Disponga las tres cajas pequeñas para tener acceso
fácil.
Remove rail sections not connected
to chain.
Enlever les sections de rail non connectées
à la chaîne.
Quite las secciones de riel no conectadas a
la cadena.
Arrange rails in line and pull plastic sleeve off chain.
Arranger les rails en ligne et tirer sur le manchon en plastique
pour le dégager de la chaîne.
Disponga los rieles en línea y estire la camisa de plástico fuera
de la cadena.
Follow instructions in the Installation Manual for assembly steps.
Procéder selon les instructions stipulées dans le manuel d'installation pour les étapes de
montage à suivre.
Si l i t i l M l d i t l ió l d t j
Box Contents Sheet
Header Bracket
Wire
Insulated Staple
Wall Button
OR
Carpenter's level
Wire strippers
Adjustable wrench
1/4", 7/16", 3/8" and
1/2" Sockets
Child can be pinned under automatic garage door.
Death or serious injury can result.
•
Never let child walk or run under moving door.
•
Never let child use door opener controls.
•
Always keep moving door in sight.
•
If person is pinned, push control button or use
emergency release.
•
Test door opener monthly:
Refer to your owner' s manual.
'
1
Place 1 / -inch object (or 2x4 laid flat) on floor.
2
If door fails to reverse on contact, adjust opener.
If opener still fails to reverse door, repair or replace opener.
Do not remove or paint over this label.
Mount wall control out of child's reach (at least 5 feet above floor).
Place next to wall control.
Entrapment Warning
Label
Three-button
Door
Remote Control
Bracket
Rail Section Clamp
End Rail Section
Center Rail Section
Head Rail (Chain) Section
Head Rail (Belt) Section
Hammer
.
©1999