Table of Contents
Advertisement
Connections
Use a standard antenna cable to connect the wall jack to the ANT IN Jack on STB.
STB connection to the antenna
To the antenna
WHEN CONNECTING TO CABLE BOX ALSO:
To the antenna
ANT. IN
1 Use a standard antenna cable to connect the wall jack to the
ANT IN Jack on STB.
NOTE:
Refer to the following pages for the connection to TV.
2 Use an incoming cable to connect to an antenna input jack on
the cable box.
3 Use a standard antenna cable to connect an antenna output
jack on the cable box to an antenna input jack on the TV.
4 After completing the connection to TV, plug the AC power
cord of the TV into the AC outlet, then turn the TV on.
5 Select the output channel from the cable box; ie ch3 or ch 4.
NOTE:
Refer to the TV owner's manual for further information.
6 Plug the AC power cord of STB into the AC outlet, then turn
STB on.
18
Connections to antenna
Incoming cable
signals
CABLE BOX
ANT
IN
NOTE:
Antenna and antenna cable are not included.
Rear panel of STB
NOTE:
Antenna, antenna cable and Cable box are not included.
TV
ANT
ANT-IN
Jack
OUT
Antenna cable
STB
Note to the Cable TV System
Installer :
This reminder is provided to call
the Cable TV system installer's
attention to Article 820-40 of the
National Electrical Code, which
provides guidelines for proper
grounding - in particular,
specifying that the cable ground
shall be connected to the grounding
system of the building, as close to
the point of cable entry as possible.
Refer to following
pages for the
connection to TV.
Advertisement
Table of Contents
