Connecting The Antenna; Attaching The Belt Clip - Radio Shack 20-164 User Manual

Connecting the Antenna

To.connect.an.external.antenna,.always.follow.
the.installation.instructions.supplied.with.the.
antenna..Use.50-ohm,.RG-58,.or.RG-8,.coaxial.
cable..If.the.antenna.is.over.50.feet.from.the.
scanner,.use.RG-8.low-loss.dielectric.coaxial.
cable..If.necessary,.RadioShack.carries.a.variety.
of.adapters..
To attach the supplied
antenna:
1.. Align.the.antenna.
slots.with.the.
tabs.on.the.
scanner,.and.slide.
the.antenna.into.
place.
2.. Turn.while.pushing.
down.until.the.
antenna.locks.into.
place.
Warning:.Use.extreme.
caution.when.installing.
or.removing.an.outdoor.antenna..If.the.antenna.
starts.to.fall,.let.it.go!.It.could.contact.overhead.
power.lines..If.the.antenna.touches.a.power.
line,.touching.the.antenna,.mast,.cable,.or.guy.
wires.can.cause.electrocution.and.death..Call.
the.power.company.to.remove.the.antenna..DO.
NOT.attempt.to.do.so.yourself.

Attaching the Belt Clip

To.carry.your.scanner,.slide.the.
supplied.belt.clip.down.on.the.back.
of.the.scanner..To.remove.the.belt.
clip,.pull.the.tab.out.and.slide.the.
clip.upward.