Step 2: Connecting The Audio Cables - Kogan KABRP21SLMB User Manual

Notes on connecting to the HDMI OUT
C
jack
Observe the following as improper handling may
damage the HDMI OUT jack and the connector.
Carefully align the HDMI OUT jack on the
back of the player and the HDMI connector
by checking their shapes. Make sure the
connector is not upside down or tilted.
Be sure to disconnect the HDMI cable when
moving the player.
If you place the player on the cabinet with the
HDMI cable connected, do not apply too much
pressure to the cabinet wall. It may damage the
HDMI OUT jack or the HDMI cable.
When connecting or disconnecting, do not
screw in or rotate the HDMI connector.
Notes:
1
television sets are fully compatible with this
product and may cause artifacts to be displayed
in the picture. In the case of 480i/ 480p/ 576p/
720p/ 1080i/1080p scan picture problems it is
recommended that the user switch the connection
to the 'HDMI Auto' output. If there are questions
regarding our TV set compatibility with this model
480i/480p/576p/720p/1080i/1080p Blu-ray Disc
player, please contact our customer service
centre.
2 Be sure to use only an HDMI cord that bears
the HDMI logo.
Step 2: Connecting the Audio
Cables
A Connecting to analogue stereo system
This connection will use your TV's speakers for
sound output.
Rear panel of Blu-ray disc player
B Connecting to an
with Coaxial Input jack(Only for the
player that have a coaxial output jack)
Connect one end of a coaxial cable (not supplied)
to the COAXIAL jack on your blu-ray player, and
connect the other end to the COAXIAL input jack
er (receiver).*
Rear panel of Blu-ray disc player
nition
TO COAXIAL
OUTPUT
Coaxial cable (not supplied)
Notes:
1. For correct speaker location, see the operating
instructions of the connected components.
2.
(receiver) with 5.1 ch (or less) audio input.
13
TV
INPUT
VIDEO
L
AUDIO
Stereo audio cable
R
(supplied)
Signal ow
er (Receiver)
er (Receiver)
To COAXIAL
INPUT
Signal ow
er