Page 3
squashed or damaged power plug may over- Installation heat and cause a fire. Important! For electrical connection carefully follow 3. Make sure that you can come to the mains plug the instructions given in specific paragraphs. of the appliance. • Unpack the appliance and check if there are dam- 4.
Operation Switching on +10 ... +16 ºC "1-2" Insert the plug into the wall socket. +16 ... +25ºC "2-3" Turn the Temperature regulator clockwise to a medium setting. +25... +32ºC "3-4" Switching off +32... +38ºC "3-4" To turn off the appliance, turn the Temperature regu- However, the exact setting should be chosen keeping lator to the "O"...
Daily use Movable shelves Using of the ice-maker compartment This appliance is equipped with an ice-maker compart- The walls of the refriger- ment. ator are equipped with a In the ice-maker compartment can be reached -2 °C or series of runners so that lower temperature depending on setting of thermostat the shelves can be posi- control.
ward warmer settings to allow automatic defrosting Cooked foods, cold dishes, etc..: these should be cov- and so a saving in electricity consumption. ered and may be placed on any shelf. Fruit and vegetables: these should be thoroughly Hints for fresh food refrigeration cleaned and placed in the special drawer(s) provided.
1. disconnect the appliance from electricity supply Warning! Never use sharp metal tools to scrape off frost from the evaporator as you could damage 2. remove all food it. Do not use a mechanical device or any artificial 3. defrost and clean the appliance and all accessories means to speed up the thawing process other than 4.
Problem Possible cause Solution The temperature in the appli- The temperature regulator is not set Set a higher temperature. ance is too low. correctly. The temperature in the appli- The temperature regulator is not set Set a lower temperature. ance is too high. correctly.
Installation Levelling Caution! Read the "Safety Information" carefully for your safety and correct operation of the When placing the appli- appliance before installing the appliance. ance ensure that it Positioning stands level. This can be Install this appliance at a location where the ambient achieved by two adjusta- temperature corresponds to the climate class indicated ble feet at the bottom in...
1. Remove the plug from 8. Unscrew both screws 10. Unscrew the screws of 16. Remove and install the power socket. on the rear side. the door top hinge. the handle on the oppo- 2. Tilt back the appliance 9. Push back the top and 11.
Environmental concerns potential negative consequences for the environment The symbol on the product or on its packaging and human health, which could otherwise be caused indicates that this product may not be treated as by inappropriate waste handling of this product. For household waste.
Need help?
Do you have a question about the FM850S/6 and is the answer not in the manual?
Questions and answers