Sound Signals; Troubleshooting - Oregon Scientific OS5851L-BR User Manual

086L004968-026
29/75
REV:1
NEW CALL
NO CALLS
NO DATA
REPT
UNKNOWN NUMBER/
NAME/CALLER
PAGING
RINGER=OFF

SOUND SIGNALS

A long warbling tone
Single Tone
Three short beeps
Two long beeps
One short beep and one long beep
Three beeps every 2 seconds
Two short beeps every 15 seconds

TROUBLESHOOTING

CALLER ID
No display
• Is battery fully charged? Try replacing the battery.
• Make sure that the base is connected to a non-switched AC outlet.
Disconnect the base from the plug and plug it in again.
• Did you order Caller ID service from your local telephone company?
The display will not work unless you do this.
Caller ID error message
• The phone displays this message if it detects anything other than valid Caller ID
information during the silent period after the first ring. This message indicates
either the presence of noise on the line, or that an invalid message has been sent
from the telephone company.
Indicates call or calls have not been reviewed.
There are no Caller ID records stored to memory.
No Caller ID information was received.
Repeat call.
The incoming call is from an area not serviced by Caller ID, or the
information was not sent.
Someone has pressed the PAGE key on the base.
Ringer ON/OFF switch on the right side is set to OFF.
Signals an incoming call
A key is pressed
Error tone
Confirmation tone
Page signal
Transfer signal
Low battery warning
25