Advertisement
BCO65 GB
6-06-2002
INSTALLATION
• Place the appliance on a flat work surface
away from water sources such as taps or sinks.
• Check that the voltage of the electrical power
line corresponds to the voltage indicated on the
appliance label. Connect the appliance only to
a power source having a minimum load
capacity of 10 amps and having a proper
grounding feature. The manufacturer takes no
responsibility for any accidents caused by the
lack of a grounding device for the appliance.
• Never install the machine in an environment
which can reach a temperature of less than or
equal to 0°C (if the water inside the machine
freezes, the machine might be damaged):
HOW TO PREPARE DRIP COFFEE
• Raise the lid and remove the water tank (fig.
1).
• Fill the tank with cold, clean water, up to the
level indicated on the tank corresponding to
the number of cups of coffee that are desired
(fig. 2).
• Insert the tank into the machine by pressing it
slightly. If desired, the tank can be left in its
place and to fill it, the drip coffee pot can be
used which also has the level indicators on it
(fig. 3).
• Open the filter holder by swinging it out to the
left (fig. 4).
• Place the paper filter into the filter holder (fig.
5). We recommend using #4 type paper fil-
ters.
• Put the ground coffee into the filter by using the
measuring spoon included with the machine
and level off the grounds uniformly (fig. 6). As
a general rule, use one level measuring spoon-
ful of coffee (about 7 grams) for each cup of
coffee (for example, use 10 measures to make
10 cups of coffee). In any case, the quantity of
ground coffee to use can vary according to the
strength desired and personal taste. Use high
quality ground coffee, with a medium grind
and the kind packaged especially for drip cof-
fee makers.
• Close the filter holder and place the pot, with
its lid inserted, onto the hot plate.
9:14
Pagina 7
• Select the aroma desired as indicated in the
paragraph "How to select the aroma".
• Press the "ON/OFF" switch for drip coffee (fig.
7).
The ON indicator light for drip coffee
above the switch itself indicates that the coffee
machine filter is functioning properly.
• For models with 5/10 cup switch (8) only:
If more than five cups of coffee are desired,
press the switch (
10
and the 5/10 cup indicator light will light up.
If, on the other hand, five or fewer cups of cof-
fee are desired, the switch should not be
pressed. In this way, the hot water will flow
more slowly through the ground coffee and a
more flavourful beverage will be obtained.
• The brewed coffee will begin to drip out after
a few seconds. It is completely normal that
during the percolation of the coffee, some
steam may escape from the machine.
• If you keep "ON/OFF" switch for drip coffee
ion the ON position after the percolation, the
warming plate will mantain the hot coffee at
an ideal drinking temperature.
HOW TO SELECT THE AROMA OF THE FILTER
COFFEE
With the Flavour System , it is possible to select the
aroma of the filter coffee depending on personal
taste. By turning the aroma regulation knob of the
coffee filter (fig. 9), the coffee machine can be pro-
grammed for a strong flavour (STRONG position)
or a lighter flavour (LIGHT position).
The Flavour System feature changes the flavour of
the coffee, more or less strong, while the true taste
of the coffee remains unchanged.
HOW TO PREPARE ESPRESSO COFFEE
1. Unscrew the plug of the hot water heater tank
by turning it in a counter-clockwise direction.
2. Using the level indications stamped on the
WATER LEVEL side, fill the small pot with the
amount of water suggested (fig. 10) according
to the number of cups of espresso coffee that
are desired (see the chart at the end of this
text).
3. Pour the water into the hot water heater tank
(fig. 11).
) (fig. 8)
5
7
Advertisement
