Table of Contents
Advertisement
Once the bearing tracking system has been set, the
compass segments on the display will show how far you
deviate from your locked course. See the examples
below:
1. The locked bearing is 94° and
2. Current compass bearing
3. Locked compass bearing
1. Your locked bearing is 94° and
2. Current compass bearing
3. Locked compass bearing
The compass segments now show the angle between
your locked bearing and your current bearing. Therefore,
you need to change the direction you are on to get back
onto your locked bearing course.
RA202/282_EN
the current bearing is 94°
your current bearing is 120°.
19
SET THE DECLINATION
Declination is the angle between where a compass needle
points (magnetic North Pole) and the true North Pole. The
declination angle can vary from 0-30 degrees East (E) or
West (W) and can be found on most maps or on the Internet.
When you set the declination angle on the compass you
compensate for the difference between true north and
magnetic north. This makes the compass reading more
accurate.
1. In any compass display screen,
press SET until the screen
opposite appears.
2. Press and hold SET to enter
setting mode.
3. Press + or - to change the setting.
4. Press SET to confirm.
19
1/27/05, 4:55 PM
Advertisement
Table of Contents
