Weather.mode.(Wx.mode) - Uniden Bearcat 980 SSB Owner's Manual

Selector clockwise to move to the next channel or counter-
clockwise to move to the previous channel. The radio
continues scanning in the selected direction.
• To change to Memory Channel Scan mode, press MEM/SCAN
while in All Channel Scan mode (see page 10).
3. To exit All Channel Scan mode, press PTT, 9/19/NORM, WEATHER,
or CB/PA.

Weather.moDe.(WX.moDe)

Your radio combines a CB radio with a Weather radio and a Weather
Alert system. The Weather Alert system sounds a 7-second signal in the
event of severe weather when in CB mode. The Weather radio continually
broadcasts weather conditions when you are in Weather mode.
1. Press WEATHER. Your radio is now in Weather radio mode.
2. Select 1 of 7 weather channels using Channel Selector.
You cannot change ANL or NB settings while in WX mode. The radio will
sound an alert tone.
Set Weather Scan Mode
Weather Scan mode allows the radio to move to the next weather
channel if no signal is detected after 3 seconds. Set Weather Scan mode
to ON or OFF through the menus.
1. Press MENU/OK to activate the menus. COLOR displays.
2. Turn the Channel Selector knob to cycle through the menu op-
tions until WXSCAN displays.
3. Press MENU/OK. ON displays.
4. Press MENU/OK to set Weather Scan mode to ON or turn the selec-
tion knob until OFF displays and then press MENU/OK to set it.
WXSCAN displays again.
If Weather Scan is
ON
when you turn off the radio, it remains
E-11
ON
.