Do you have a question about the 5500EXL and is the answer not in the manual?
Questions and answers
Michael Keller
February 3, 2025
I installed new brushes and new voltage regulator but still no ac output
1 comments:
Mr. Anderson
February 10, 2025
Possible causes of no AC output after installing new brushes and a new voltage regulator on a Generac Power Systems 5500EXL generator include:
1. Circuit Breaker Tripped – Check if the circuit breaker is open and reset it if necessary. 2. Faulty or Incorrect Connections – Ensure the new brushes and voltage regulator are properly installed and connected. 3. Defective Voltage Regulator – The new voltage regulator may be faulty; consider testing or replacing it. 4. Shorted Generator Circuit – A short in the generator's electrical circuit may prevent AC output; contact a Generac service facility. 5. Damaged Rotor or Stator – A malfunction in the rotor or stator windings could prevent proper voltage generation. 6. Excitation Loss – The generator may need to be re-excited if it has lost residual magnetism.
If the issue persists, professional servicing may be required.
Need help?
Do you have a question about the 5500EXL and is the answer not in the manual?
Questions and answers
I installed new brushes and new voltage regulator but still no ac output
Possible causes of no AC output after installing new brushes and a new voltage regulator on a Generac Power Systems 5500EXL generator include:
1. Circuit Breaker Tripped – Check if the circuit breaker is open and reset it if necessary.
2. Faulty or Incorrect Connections – Ensure the new brushes and voltage regulator are properly installed and connected.
3. Defective Voltage Regulator – The new voltage regulator may be faulty; consider testing or replacing it.
4. Shorted Generator Circuit – A short in the generator's electrical circuit may prevent AC output; contact a Generac service facility.
5. Damaged Rotor or Stator – A malfunction in the rotor or stator windings could prevent proper voltage generation.
6. Excitation Loss – The generator may need to be re-excited if it has lost residual magnetism.
If the issue persists, professional servicing may be required.
This answer is automatically generated