McIntosh MS300 Advanced User's Manual page 40

3. Slowly enter "997" using the number buttons on the keyboard. The LED will
flash twice again.
4. Press the "CH-" button on the left side of the keyboard. The LED will flash four
times.
5. Press the MS300 (swoop) source button.
6. Press & Hold the "Set" button on the keyboard until the LED flashes twice.
7. Slowly enter:
o 1119 for the MS1 button
o 1120 for the MS2 button
o 1121 for the MS3 button
o 1122 for the MS4 button
8. The LED will again flash twice indicating the programming was successful.
The transport buttons on the top right of the keyboard are programmed to operate the
MS300, however, they are actually programmed onto the CBL source buttons.
The CBL button functions as the MS1 remote source button on the keyboard. This button
"punches-thru" to the swoop key so that both are enabled when either the Swoop or the
CBL button has been pressed. However, the CBL button is not available as a universal
source when it has been programmed as the MS300 transport source button.
DO NOT program the CBL source button to control any other devices. Doing so will
prohibit the use of the transport keys for controlling the MS300.
If you accidentally reprogram the CBL source button, use the following steps to program
the CBL button back to control the MS300 transports:
Press the CBL source button.
Press & Hold the "Code Set" button on the remote until the LED flashes twice.
Enter the CBL reset code which corresponds to the MS source being reset:
o "1370" for MS1
o "1371" for MS2
o "1372" for MS3
o "1373" for MS4
The LED will flash twice indicating the code was accepted.
2 Chambers Street • Binghamton, NY 13903-269 Phone: 607-723-3512 / 800-538-6576 • Fax: 607-724-0549
Technical Support 866-458-6910 9:00AM to 6:00PM EST, M-F
MS300 Advanced Users Guide
Page 40 of 65
3/3/2005
www.mcintoshlabs.com