McIntosh MS300 Advanced User's Manual page 31

2. Press and hold CODE SET until the LED blinks twice, then release CODE SET.
3. Enter 9 - 9 - 0. The LED will blink twice.
4. To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED
blinks (e.g., 3 blinks = 3) NOTE: If a code digit is "0", the LED will not blink.
5. Repeat step 4 three more times for remaining digits. Use 2 for the second digit, 3
for the third digit, and 4 for the fourth digit.
To check for the codes of your other components, repeat steps 1 through 5, but substitute
the appropriate key (TV, CBL, RCV, DVD) for the component you are checking.
To exit Code Check Mode, press the CODE SET key once.
Re-Assigning Device Keys
The Remote can be set up to control a second TV, receiver or any combination of eight
home entertainment components. For example, to have the Remote control a TV, a Cable
Converter, and two DVD players, you can reassign an unused SOURCE key to operate
the second DVD player.
Follow these steps to re-assign the CBL key to control a second DVD player:
1. Press and hold CODE SET until the LED blinks twice, then release CODE SET.
2. Enter 9 - 9 - 2. The LED will blink twice.
3. Press the DVD key, then press the CBL key.
4. The CBL key is now ready to be programmed for a DVD player.
To reassign other device keys, repeat steps 1 through 4 by substituting the key sequence
from the below chart for the most popular components.
When a reassignment is done, the LED will blink twice to confirm your choice. At that
time, you will need to program the Remote to control the new component, following the
instructions above.
The following devices can be assigned to the TV, CBL, RCV, and DVD source mode
buttons on the McIntosh Remote Control.
Source Button Device Assignment
TV TV
CBL Cable, Video Accessories, Satellite, DSS
RCV Amplifier, Tuner, Phono, Misc. Audio, CD, Home Automation, MD
DVD VCR, Audio Cassette, DVD, LDP, DAT, PVR
2 Chambers Street • Binghamton, NY 13903-269 Phone: 607-723-3512 / 800-538-6576 • Fax: 607-724-0549
Technical Support 866-458-6910 9:00AM to 6:00PM EST, M-F
MS300 Advanced Users Guide
Page 31 of 65
3/3/2005
www.mcintoshlabs.com