Clean Air Intake; Checking The Engine Spark Plug; Fuel Filter; Spark Arrestor Service - Generac Power Systems 004700-0 Installation And Owner's Manual

3.4

CLEAN AIR INTAKE

Clean all foreign material from the air intake (Figure
3.3) at least once every 100 hours of operation. Clean
more often if necessary.
Inspect the area around the generator exhaust muf-
fler periodically and remove all grass, leaves, dirt,
etc., from this area.
Figure 3.3 – Cleaning Air Intake
USTC USTC
3.5 CHECKING THE ENGINE
SPARK PLUG
Clean the spark plug and reset the spark plug gap
every 100 hours of operation.
1. Clean the area around the base of the spark plug
to keep dirt and debris out of the engine. Remove
the spark plug and check the condition. Replace
the spark plug if worn or if reuse is questionable.
2. Clean spark plug by scraping or washing using a
wire brush and commercial solvent. Do not blast
the spark plug to clean.
3. Check the spark plug gap using a wire feeler
gauge. Adjust the gap to 0.030 inch (0.76 mm)
by carefully bending the ground electrode
(Figure 3.4).
Figure 3.4 – Setting the Spark Plug Gap
Sparking can occur if the wire terminal does
!
not fit firmly on the spark plug terminal end. If
necessary, re-form the wire terminal to obtain a
tight fit.
Section 3 – Maintenance
QUIETPACT 40G Recreational Vehicle Generator
3.6

FUEL FILTER

Remove and replace the fuel filter (Figure 3.5)
once each year or every 400 hours of operation,
whichever comes first. Fuel filter is removed with a
15/16" deep well socket.
3.7 CLEAN SPARK ARRESTOR
The engine exhaust muffler has a spark arrestor
screen. Inspect and clean the screen every 50 hours
of operation or once each year, whichever comes first.
If you use your generator on any forest-covered,
brush-covered or grass-covered unimproved land,
it must equipped with a spark arrestor. The spark
arrestor must be maintained in good condition by
the owner/operator.
Clean and inspect the spark arrestor as follows:
• Remove the screen retaining bracket by removing
the screw.
• Slide the spark arrestor screen out from the tail
pipe.
• Inspect screen and replace if torn, perforated or
otherwise damaged. DO NOT USE a defective
screen. If screen is not damaged, clean it with com-
mercial solvent.
• Replace the screen and the retaining bracket.
Figure 3.5 – Fuel Filter
POS
NEG
NOTE:
Figure 3.6 - Spark Arrestor
TAILPIPE
P/N 0E0683
SPARK ARRRESTOR
SCREEN P/N 089680
RETAINING
SCREW P/N 056892
Generac ® Power Systems, Inc. 13
FUEL