Unloading The Dishwasher - Electrolux ASF66850 User Manual

16 electrolux
– The delay start indicator light comes
on.
2. Close the appliance door, the countdown
starts automatically. The number in the
display is no longer flashing but fixed with
static light.
3. The countdown will decrease with steps
of 1 hour.
4. The opening of the door will interrupt the
countdown. Close the door; the count-
down will continue from the point at
which it was interrupted.
5. Once the delay start has elapsed the pro-
gramme will start automatically.
– The delay start indicator light goes off.
The selection of the washing pro-
gramme and delay start can occur also
with the door closed.
When you press a programme button
you have ONLY 3 seconds to select a
different programme or a delay start.
After these 3 seconds, the selected pro-
gramme starts automatically.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
• Press the On/Off, all indicator lights will go
off. Press the On/Off button again; the pro-
gramme will start from the point at which
it was interrupted.

Unloading the dishwasher

• Hot dishes are sensitive to knocks. The
dishes should therefore be allowed to cool
down before removing from the appliance.
• Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in
the lower one.
• Water may appear on the sides and the
door of the dishwasher as the stainless
Cancel a delay start or a washing
programme in progress
• Press and hold the cancel button, until all
the programme indicator lights come on.
• If you cancel a delay start also the washing
programme and options (except Multitab)
will be cancelled. Select the washing pro-
gramme again.
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
• The appliance stops automatically.
• The light of the programme just ended re-
mains on.
• Zero appears in the digital display.
1. Switch off the appliance.
2. Open the appliance door, leave it ajar and
wait a few minutes before removing the
dishes. This way they will be cooler and
the drying will be improved.
If the save energy function is set, dishes
can be wet at the end of the programme.
We recommend to leave the appliance
door ajar so that dishes can dry naturally.
Standby mode
If you do not switch off the appliance at the
end of the washing programme, the appli-
ance automatically goes into standby mode.
The standby mode decreases energy con-
sumption.
Three minutes after the end of the pro-
gramme, all indicator lights go off and the
digital display shows one horizontal bar.
Press one of the buttons (not the on/off but-
ton), to go back to end-of-programme mode.
steel will eventually become cooler than
the dishes.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the
water tap turned off.