Adtech ADT-TP3340DJ User Manual page 23

Input test: The top four lines display the state of input ports no matter in motor test interface or output
control interface. The normal display indicates no input signal, while the highlighted display indicates
input signal, e.g. the "Z origin" in above figure is highlighted.
VI. Description of processing point types
Insert/ Instruction/ Delete/ Save/ Other
Type: X coordinates; Y coordinates; Z coordinates; Speed: More
Single point
Start point
Linear
Arc
End point
Line: 0005/0005
Up Down
As shown in the figure above, the first point is "Single point". During processing, Z-axis feeds gun at
this point and the gun feeding position is the Z-axis coordinates of this point. When the gun feeding
is in place, the machine starts dispensing, and closes the glue gun after specified "Single point time"
and then retreats glue gun to "Needle height" position.
1. Start point
As shown in the figure above, the second point is "Start point". During processing, Z-axis feeds
gun at this point and the gun feeding position is the Z-axis coordinates of this point. When the gun
feeding is in place, the machine starts dispensing, and moves to next point after the specified "Gun
opening delay".
2. End point
As shown in the figure above, the fifth point is "End point". After moving to this point, the glue
gun is closed, and Z-axis returns to the "Needle height" position after the specified "Gun closing
delay". Please note that the processing type of "End point" allows setting closing glue gun in advance
or not (in instruction view). If advance closing is set, the glue gun will be closed when it is in
"Advance gun closing distance" from the coordinates of end point.
3. Straight line
As shown in the figure above, the third point is "Straight line", indicating moving to this point in
straight line mode.
4. Arc
As shown in the figure above, the fourth point is "Arc", indicating moving to next point through
this point in arc mode. The arc processing point type determines an arc through three points on the arc.
5. Forward/reverse circle
The forward/reverse circles are similar to arc point. The difference is that forward/reverse circles
provide the coordinates of start point, circle center and end point, while the arc provides the
coordinates of three points on the arc.
Insert/ Instruction/ Delete/
Type: X coordinates; Y coordinates; Z coordinates; Speed: More
Single point
Start point
Linear
Arc
End point
Line: 0005/0005
Up Down
Prompt: Gun closed
Copy Preview Back
Save/ Other
Prompt: Gun closed
Copy Preview Back
- 22 -
ADT-TP3340DJ Three-axis Dispenser
Magnification:0.26
Zoom in
Zoom out
Suitable
Left
Right
Up
Down
Point No.:0001 Previous point:
Magnification:0.39
Zoom in
Zoom out
Suitable
Left
Right
Up
1
Down
Point No.:0005 Previous point:
3
2
4
1
5
Next point: Select Back
5
4
3
2
Next point: Select Back