Table of Contents

Advertisement

Control Panel

Best results are obtained by using a low speed for normal conditions
and a high speed when odours are more concentrated.
Turn the hood on a few minutes before you start cooking, you will then
get an under pressure in the kitchen. The hood should be left on after
cooking for about 15 minutes or until all the odours have disappeared.
The control switches are located on the hood's front panel:
A - Mains switch, OFF.
B - Start and choice of motor speed 1-2-3
C - Indicates speed 1 (LED).
D - Indicates speed 2 and saturation of the grease filter (LED)
E - Indicates speed 3 and saturation of the charcoal filter (LED)
(flashing LED)
F - Indicates Intensive speed (LED).
G - Intensive speed on/off. The Intensive speed runs for 5 minutes:
If the hood is on when the Intensive speed is activated, the hood
reverts to previous speed after 5 minutes.
If the hood is off when the Intensive speed is activated, the hood
will be turned off after 5 minutes.
To interrupt the Intensive speed, press button A or B.
H - Light OFF
I
- Light ON
A
B C D E
Fig. 2
Should the hood or the controls fail to operate: disconnect the power
supply for at least 5 seconds, then turn the hood back on again.
F
G
H
I
7

Advertisement

Table of Contents
loading

Table of Contents