Electrolux EWW1649 Instruction Booklet page 26

Problem
• The door will not open:
• Spinning starts late or the laundry is
not spun enough:
• The machine will not dry or the
laundry is not dry enough
• The machine makes an unusual noise
• No water is visible in the drum
If you are unable to identify or solve the problem,
contact our service centre. Before telephoning, make
a note of the model, serial number and purchase
date of your machine: the Service Centre will require
this information.
Possible cause
• The water level is above the bottom edge of the door.
• The machine is heating the water or drying clothes.
• The drum is turning.
The door can only be opened when the door
locked light is off.
• The electronic unbalance detection device has cut
in because the laundry is not evenly distributed in
the drum. The laundry is redistributed by reverse
rotation of the drum. This may happen several
times before the unbalance disappears and normal
spinning can resume. If, after 10 minutes, the
laundry is still not evenly distributed in the drum,
the machine will spin at a lower speed. If at the end
of the programme the laundry is not spun enough,
redistribute the load manually and select the spin
programme.
• The water tap is closed (E10).
• The drain pump is clogged (E20).
• The drying time or degree of dryness has not been
selected.
• An appropriate drying time has not been chosen.
• There is too much laundry inside the appliance.
• The machine is fitted with a type of motor which
makes an unusual noise compared with other
traditional motors. This new motor ensures a softer
start and more even distribution of the laundry in
the drum when spinning, as well as increased
stability of the machine.
• Machines based on modern technology operate
very economically using very little water without
affecting performance.
Mod. ..........
Prod. No. ...........
Ser. No. .........
26