After Sales Service - Electrolux EWT800 Instruction Book

Symptom
**
The «End»* light flashes 4 times
The «End»* light ** flashes 2 times***:
The «End»* light ** flashes 1 time***:
The «End»* light** flashes 10 times ***
Softener or Javel water flows through the over-
flow orifice when filling* :
* Depending on the model.
** Eliminate the causes of the failure if you find them, and then press on the «Start/Pause» pusbutton to restart the
interrupted program.
*** Depending on the model, some acoustic signals may be activated.

8. AFTER SALES SERVICE

If you have an operating problem, refer to the "Operating problems" section. If any work is necessary after you have made
all your checks, please contact your washing machine dealer.
When you call the After Sales Service, mention the model and product number of your washing machine, and its serial num-
ber. This information is given on the inside of the filter door and on the name plate at the back of the washing machine.
If any work is done on your washing machine, insist that your After Sales Service uses manufacturer certified spare parts.
Cause
***
: • the cover is not correctly closed.
• the drain filter is blocked,
• the drain pipe is blocked or kinked,
• the drain pipe is too high (see «installation»),
• the drain pump is blocked,
• the installation siphon is blocked.
• the water tap is closed,
• the water network has been cut off.
• The flaps of the drum door are opened.
• you did not put in the right amount,
• the siphons at the back of the detergents dispenser are
blocked.
12