Trouble Shooting - Electrolux EUF 1056 Instruction Book

Trouble shooting

During operation of the appliance some smaller but annoy-
ing trouble can often occur, which does not require calling
a technician out. In the following chart information is given
about them to avoid unnecessary charges on service.
We draw your attention that operation of appliance goes with
certain sounds (compressor- and circulating sound). This is
not trouble, but means normal operation.
We draw it to your attention again that the appliance
operates discontinuously, so the stopping of com-
pressor does not mean being no-current. That is why you
must not touch the electrical parts of the appliance before
removing it from the mains socket.
Problem
The appliance does not cool
sufficiently
The appliance cools too hard
The appliance does not cool
at all
The appliance is noisy
As much as the advice does not lead to result, call the nearest brand-mark service.
Power or operation failure:
In case of power failure during the storage of frozen foods, make sure not to open the freezer door. Once the power fail-
ure is over, the yellow indicator (3) of the quick freeze function will light up and then, 5 hours after restart, it will automat-
ically go out.
If a short power failure occurs (max. 13 hours) and the product is full, the stored foods will not deteriorate. Otherwise you
must use the stored food as soon as possible (if the temperature of the frozen foods rises, their storability will be short-
er).
Check stability of product support (all four feet should stand on floor).
If you fail to remedy a problem, please contact the nearest authorized service unit.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The product will
continue to operate with the use of a reserve system until the problem is eliminated by the local service personnel.
Possible cause
Thermostatic control is set too low.
Before freezing the appliance was not precooled
sufficiently.
Large-sized food was put in.
Too many foods to be frozen were put in.
Warm foods were put in.
Door is not shut properly.
The thermostatic control is set too high.
Plug is not connected to the mains socket proper-
ly.
There is no voltage in the mains socket.
Thermostat set to "0" position.
The appliance is not supported properly.
Solution
Set higher position.
Pre-cool the appliance for enough time.
Cut up food.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check thermostat setting.
Check if the appliance stands stable (all the four
feet should be on the floor).
GB
47