Regular Cleaning; When The Refrigerator Is Not In Use; Trouble Shooting - Electrolux EUC 19001 W Instruction Book

Hide thumbs Also See for EUC 19001 W:
Table of Contents

Advertisement

Available languages

Available languages

that it can be collected in a drain at the
bottom of the product and then remove
the water as follows:
Place a tray of sufficient height in front of
the product.
Following the arrow, carefully pull out the
defrost water drain, located in the central
bottom section of the product, to let the
defrost water flow into the tray.
The defrosting process will be quicker if
you put a pan filled with hot water on the
cooling plates used as shelves.
Once defrosting is completed, dry the
wet surfaces and push back the defrost
water drain.
Connect the product to the mains.
Rotate the thermostat to position << -
18°C >> and let the product operate in
quick freeze mode for at least 2 hours
before putting back the formerly removed
frozen foods.

Regular cleaning

It is practical to clean the inside of the
freezer and defrost it at a time.
Household cleaner or soap must not be
used.
After breaking the circuit wash the
appliance using lukewarm water and
wipe it.
Clean the door gasket with clean water.
After cleaning apply voltage to the
appliance.
It is recommended to remove the dust
and dirt collected on the back of the
appliance and the condenser once or
twice a year.

When the refrigerator is not in use

If you do not use the product for longer
periods, make sure to perform the
following:
Set the thermostat to position <<
Disconnect the product from the mains.
Remove all foods from the product.
Perform
defrosting
operations as described above.
Leave the doors ajar to avoid the build-up
of unpleasant odors.

Trouble shooting

During operation of the appliance some
smaller but annoying trouble can often
occur, which does not require calling a
technician out. In the following chart
information is given about them to avoid
unnecessary charges on service.
We draw your attention that operation of
appliance goes with certain sounds
(compressor- and circulating sound). This
is not trouble, but means normal
operation.
We draw it to your attention again
that
the
discontinuously, so the stopping of
compressor does not mean being no-
current. That is why you must not touch
the electrical parts of the appliance
before removing it from the mains socket.
electrolux 51
GB
>>.
and
cleaning
appliance
operates

Advertisement

Table of Contents
loading

Table of Contents