Delay Start Button - Electrolux EW1220N Instruction Book

Example:
PREWASH
ÖN YIKAMA
WASH
YIKAMA
RINSES
DURULAMA
SPIN
SIKMA
DRAIN
BOSALTMA
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
- depress SKIP/RESET once or repeatidly to cancel
the previously performed programme;
- select the type of fabric by means of button
"ÇAMASIR";
- select the special programme:
• RINSES (DURULAMA)
Depress SKIP/RESET once, the pilot light YIKAMA
(WASH) goes out.
• SPIN (SIKMA)
Depress SKIP/RESET twice, the pilot lights
YIKAMA (WASH) and DURULAMA (RINSES) go
out.
• DRAIN (BOÇALTMA)
Depress SKIP/RESET three times, the pilot lights
YIKAMA (WASH), DURULAMA (RINSES) and
SIKMA (SPIN) go out.
Example:
PREWASH
ÖN YIKAMA
WASH
YIKAMA
RINSES
DURULAMA
SPIN
SIKMA
DRAIN
BOSALTMA
• If the machine is switched off:
- depress ON/OFF (AÇMA/KAPAMA) button to
switch it on;
- select the type of fabric by means of button
"ÇAMAÇIR";
- select the special programme as previously described.
In this case, both the
drain and the spin (at
the speed provided for
the selected type of
fabric) will be
performed.
In this case the machine
will perform the rinses
followed by the spin.

11 DELAY START button

(GECIKTIRME)
This button makes it possible to delay the starting of
the programme by up to 24 hours. The delay you
have selected is shown on the display for about 5
seconds; afterwards, the duration of the programme
reappears.
You must select this option after you have set the
programme and before you press the
START/PAUSE button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to change or cancel the delay
time, proceed as follows:
• set the washing machine to PAUSE by pressing the
START/PAUSE button;
• press the DELAY button until the display shows the
desired delay time or
• press the DELAY button once, to erase the delay
time. The display will indicate "0h".
• press the START/PAUSE button again.
Important!
The door will be locked throughout the delay time
(DOOR LOCKED light lit).
If you need to open the door, you must first set the
washing machine to PAUSE by pressing the
START/PAUSE button. After you have closed the
door, press the START/PAUSE button again.
12 Programme phase indicator lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
PREWASH
ÖN YIKAMA
WASH
YIKAMA
RINSES
DURULAMA
SPIN
SIKMA
DRAIN
BOSALTMA
13
After you have started
the programme, only
the light relevant to
the phase that is
currently being carried
out will remain lit.