Table of Contents
Advertisement
To change the light bulb
The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Cut the packaging around the bulb socket.
Keep the packaging on to hold the bulb when setting
it into the socket. Do not touch the bulb with your
bare fingers. Halogen light bulbs are sensitive to
grease from the skin.
Use a clear halogen light bulb.
Change of carbon filter
To maintain the best performance the carbon filter
should be changed once a year with normal usage.
New carbon filters can be purchased from your local
dealer. The filter is placed behind the grill and can be
reached by opening the cover. The cover can be
opened by simultaneously pressing the lever on the
right of grill (1) and turning the cover outward (2).
The carbon filter is then pulled out of its slot (3).
The new carbon filter is placed in the existing slot -
The filter should be handled carefully so fragments
don't loosen from the surface.
When the appliance is not in use
Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside
from spoiling in case of a power failure.
Something Not Working
Before contacting your local Service Force Centre check the following point:
Problem
" " is displayed in the temperature
display.
It is too warm inside the refrigerator.
It is too cold inside the refrigerator.
Water comes out on the floor.
The compressor operates continuously.
G4
20W/12V
1
2
Possible cause / Remedy
An error has occurred in measuring the temperature. Call your
service representative. (The cooling system will continue to
keep food products cold, but temperature adjustment will not
be possible.)
Set a lower temperature.
Put food products in the right place inside the refrigerator. See
the chapter "Temperature inside the refrigerator".
Distribute the food products to allow cold air to circulate
around them.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
Set a warmer temperature.
Place the drain hose at the back of the cabinet above the drain
bowl. See the chapter "Before using the cabinet the first time".
Set a warmer temperature.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
55
UV-blocked
Low pressure
3
GB
Electrolux 8183792-00/4
Advertisement
Table of Contents
