Electrolux EDE56140W User Manual page 11

125985340_gb.qxp 2006-08-31
programme is running, this button
must be pressed again after closing
the door in order to restart the pro-
gramme from the point at which it was
interrupted.
In both cases the light of the
Start/Pause button flashes to remind
you that the start button needs to be
pressed again.
I I n n d d i i c c a a t t o o r r l l i i g g h h t t s s
These lights indicate the following
functions:
" " D D r r y y i i n n g g " " l l i i g g h h t t
This light indicates that the appliance is
in the drying phase.
" " C C o o o o l l i i n n g g " " l l i i g g h h t t
This light indicates that the appliance is
in the cooling phase. At the end of
drying, there is a 10 minute cooling
phase to cool the laundry.
" " E E n n d d o o f f p p r r o o g g r r a a m m m m e e " " l l i i g g h h t t
This light is on at the end of the cooling
phase, during the anti-creasing phase
and at the end of the programme.
" " F F i i l l t t e e r r c c l l e e a a n n i i n n g g " " l l i i g g h h t t
It comes on every 80 cycles to remind
you that the condenser must be
cleaned.
At the end of the programme
All drying programmes end with a 10
minute cooling phase.
If the laundry is not removed at the end
of the cycle, the dryer performs an
anti-creasing phase (duration: 30 min-
utes maximum).
If you do not remove the laundry, the
dryer will stop automatically at the end
of the anti-creasing phase.
Lights end and filter remain lit and the
buzzer sounds for 2 minutes.
Turn the programme selector dial to "0";
07:43 Page 11
all the lights go out. The appliance is
switched off.
Remove the laundry.
If you open and then close the door
before turning the selector dial to "0" all
the indicator lights come on.
A A f f t t e e r r e e a a c c h h u u s s e e
• Clean the filters.
Important!
If the drying programme has to be
stopped before it reaches the end, we
recommend that you turn the pro-
gramme selector dial to position Cooling
and wait until the end of this cooling
phase before removing the laundry. This
will avoid a build-up of heat inside the
appliance.To do this first turn the dial to
"O O " and then to Cooling
Start button.
M M o o d d i i f f y y i i n n g g t t h h e e p p r r o o g g r r a a m m m m e e
To change a programme which is run-
ning, first cancel it by turning the pro-
gramme selector dial to "O O ". Select the
new programme and press the Start
button .
use electrolux 11
GB
and depress