Table of Contents
Advertisement
Door reversal
1 Remove screws (A) which secure the top (B)
rear brackets.
2.Move the top (B) slightly to release it from the
retainers and remove it.
3. Unscrew top hinge (C) and reÞt it on the opposite
side.
4. Refit the top (B).
Installation
Take utmost care when handling your
appliance so as not to cause any damages to
the cooling unit with consequent possible fluid
leakages.
¥ During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
¥ Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
to the
B
A
5. Remove bottom hinge (E) and unscrew part (F)
6. Unscrew the handle (D). Refit it on the opposite
C
Positioning
¥ Unpack the cabinet and check that it is in good
¥ Place the refrigerator away from direct sunlight and
¥ The appliance must not be located close to
¥ Maintain recommended ventilation.
F
and reÞt them on the opposite side.
side after having pierced the plugs with a punch.
Cover the holes left open with the plugs contained
in the documentation pack.
Warning!
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting
of the gasket or accelerate this process by
heating up the part involved with a normal
hairdrier.
condition and free of any transport damage.
heat sources.
radiators or gas cookers.
D
E
7
Advertisement
Table of Contents
