What To Do If - Electrolux ESF68070 User Manual

7. Put the filter (B) to its initial position.
Make sure that it assembles correctly in
the two guides (C).

WHAT TO DO IF...

The appliance does not start or stops dur-
ing operation.
Malfunction
The appliance does
not fill with water.
The appliance does
not drain the water.
C
Fault code
• An audible signal
operates.
• The display shows a
message.
• An audible signal
operates.
• The display shows a
message.
8. Put the filter (A) into position in filter (B).
Turn the filter (A) clockwise until it locks.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance
and control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (acetone).
First try to find a solution to the problem (re-
fer to the chart). If not, contact the service
centre.
Possible cause
The water tap is
closed.
The water pressure is
too low.
The water tap is
blocked or is furred
with limescale.
The filter in the water
inlet hose is blocked.
The connection of the
water inlet hose is not
correct.
The water inlet hose is
damaged.
There is a blockage in
the sink spigot.
The connection of the
water drain hose is not
correct.
The water drain hose
is damaged.
electrolux 15
Possible solution
Open the water tap.
Contact your local wa-
ter authority.
Clean the water tap.
Clean the filter.
Make sure that the
connection is correct.
Make sure that the wa-
ter inlet hose has no
damages.
Clean the sink spigot.
Make sure that the
connection is correct.
Make sure that the wa-
ter drain hose has no
damages.