Harman Kardon BDS 275 Owner's Manual page 12

BDS
Connecting Your Coaxial Digital Audio Source Device
If one of your non-HDMI source devices has a coaxial digital output, connect it to the
receiver's Coaxial Digital Input connector. NOTe: Make only one type of digital connection
(HDMI, optical or coaxial) from each device.
Coaxial-Equipped
Source Device
To Coaxial Digital
Audio Output
Connecting Your Analog Audio Source Devices
Use the receiver's aux In connectors for up to two source devices that don't have HDMI
or digital audio connectors.
To Stereo Analog
Audio Output
Stereo Audio Cable
12
Coaxial Digital Audio
Cable (not supplied)
Analog
Source Device
(not supplied)
Connecting to Your Home
Use a Cat. 5/5e network cable (not supplied) to connect the BDs receiver's Network
connector directly to your home network router, network switch, network modem or
ethernet network wall jack that has Internet access. see General Settings: Network, on
page 17, for information about joining the BDs receiver with your home network.
Cat. 5/5E (not supplied)
Connect the Subwoofer Trigger Output
If your system has equipment that can be controlled by a DC trigger signal, connect it
to the receiver's subwoofer Trigger connector with a mono 1/8-inch (3.5mm) mini-plug
interconnect cable (not supplied). The receiver will supply a 12V DC (100ma) trigger
signal at this connection whenever it is powered on.
Device with
Trigger In Connector
Connections
To
Internet
Network
Modem
Mono 1/8-Inch
(3.5mm)
Mini-Plug
Interconnect
(not supplied)