Table of Contents
Advertisement
Rotating Sensor Head to Change Coverage Area
5. Increase or decrease the sensitivity as needed.
Too much sensitivity may cause false triggering
due to heat sources in the coverage area (see
Troubleshooting section).
6. Set the amount of ON-TIME you want the
light to stay on after motion is detected (1, 5,
or 10 minutes). The timer will reset as long
as there is motion present. Once motion has
stopped, the timer will time-out after the
selected amount of time.
1.8 m
(6 ft.)
9.1 m
(30 ft.)
Maximum Range
(Side View)
Figure 8
Maximum
Coverage Angle*
(Top View)
Mode:
Test
5 Seconds
Auto
To Dawn*
Manual
* resets to Auto Mode at dawn.
Note: W hen first turned on wait about 1
for the circuitry to calibrate.
Manual mode only works at
night because daylight returns
the sensor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1,
5, or 10 position.
150°
MODE SWITCHING SUMMARY
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn
the power off for one minute, then back on. After
the calibration time the control will be in the AUTO
mode.
6
OPERATION
On-Time
Works: Day Night
1, 5, or 10
Minutes
MANUAL MODE
ON-TIME Switch at 1, 5,
or 10 minutes
Flip light switch
off for one second
then back on*
x
x
x
x
/
minutes
1
2
1 Second
OFF then...
... back on.
201101-01
Advertisement
Table of Contents
