Electrical Connection - Electrolux EHD 80170 P User Manual

Electrical Connection

Before connecting, check that the nominal
voltage of the appliance, that is the voltage
stated on the rating plate, corresponds to
the available supply voltage. Also check the
power rating of the appliance and ensure
that the wire is suitably sized in accordance
with local wiring rules. The rating plate is lo-
cated on the lower casing of the hob.
The heating element voltage is AC230V~.
The appliance also works perfectly on net-
works with AC220V~ or AC240V~. Means
for disconnection must be incorporated in
the fixed wiring in accordance with local wir-
ing rules.
The hob is to be connected to the mains us-
ing a device that allows the appliance to be
disconnected from the mains at all poles with
a contact opening width of at least 3 mm,
eg. automatic line protecting cut-out,earth
leakage tripsorfuse.
If this appliance's mains cable is damaged, it
must be replaced by a special cable (type
H05BB-F Tmax 90°C; or higher). The latter is
available from the Customer Care Depart-
ment.
The connection must be carried out as
shown in the diagram, refer to the sticker on
the back of the hob for wiring connection di-
agram. The connecting links should be fitted
according to the appropriate connection di-
agram. Note for single phase connection,
the link (or bridge) will need to be fitted be-
tween terminals 1 & 2 (refer to the connec-
tion sticker on back of the unit). The earth
lead is connected to terminal
lead must be longer than leads carrying elec-
tric current.
The cable connections must be made in
accordance with regulations and the
terminal screws tightened securely.
Finally, the connecting cable is to be secured
with the mains cable cleat and the covering
closed by pressing firmly (lock into place).
Before switching on for the first time, any
protective foil or stickers must be removed
from the glass ceramic surface.
Once connected to the mains supply
check that all cooking zones are ready
for use by briefly switching each on in
turn at the maximum setting.
Sticking on the seal
•
•
. The earth
A duplicate rating label is supplied with
this unit. For easy identification of this
unit after installation, stick it to a readily
available surface adjacent to the cook-
top.
Clean the worktop around the cut-out
area.
Stick the single-sided adhesive sealing
tape provided on the underside of the
hob around the outside edge ensuring
that it is not stretched. The two ends of
the tape should join in the middle of one
side. After trimming the tape (allow it to
overlap by 2-3 mm), press the two ends
together.
electrolux 23