Table of Contents
Advertisement
Unpacking
Before starting the machine up, the
packing must be removed as follows.
You are advised to keep all the packaging for
re-use in case the machine has to be
transported again.
1. Using a spanner unscrew and remove the
rear right bolt. Lay the machine gently on its
back, making sure that the hoses are not
squashed.
2. Remove the polystyrene block from
underneath the machine.
3. Release the two polythene bags by removing
the adhesive strip.
4. Carefully remove the right polythene bag (1)
by pulling it towards the centre of the
machine. Repeat the operation for the left
polythene bag (2).
5. Set the machine upright and remove the two
remaining bolts from the back.
6. Pull out the three plastic spacers from the
holes into which the bolts were fitted.
7. Plug the open holes with the plugs which you
will find in the bag containing the instruction
book.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs etc.
Check that the machine does not touch the wall
or other kitchen units.
Carefully level by screwing the adjustable feet in
or out. Never place cardboard, wood or similar
materials under the machine to compensate for
any unevenness in the floor.
INSTALLATION
P0255
P0234
P0256
P1051
2
1
P0233
P0020
25
Advertisement
Table of Contents
