Charcoal Filter; Changing The Light Bulb - Electrolux EFT611 User Manual

Charcoal filter

• The charcoal filter should only be used if you
want to use the hood in its filtering function.
• To do this you will need an original
ELECTROLUX charcoal filter (see special
accessories).
• Cleaning/replacing the carbon filter
Unlike other carbon filters, the LONGLIFE
charcoal filter can be cleaned and reactivated.
At normal use the filter should be cleaned every
second month. The best way to clean the filter
is in the dishwasher. Use normal detergent and
choose the highest temperature (65º C). Wash
the filter separately so that no food parts gets
stuck on the filter and later causes bad odours.
To reactivate the charcoal, the filter should be
dried in an oven for 10 minutes with a tempera-
ture of maximum 100º C.
After approximately three years of use, the
carbon filter should be replaced with a new, as
the odour reduction capacity will be reduced.
• Mounting
Remove the grease filters and fit one LONG
LIFE carbon filter S on the rear side of each
grease filter, fix each with two metal wires Z .
Fig. 5.
• To dismount proceed in reverse order.
• Always specify the hood model code number
and serial number when ordering replacement
filters. This information is shown on the
registration plate located on the inside of the
unit.
• The charcoal filter can be ordered from the
ELECTROLUX technical assistance service.

Changing the light bulb

• Disconnect the cooker hood from the main
supply.
• Remove the grease filter.
• Replace the old bulb with a new one of the
same type.
• Refit the grease filter.
• If the light does not come on, make sure the
bulb has been inserted in correctly before
contacting the technical assistance service.
31
Fig. 5