Starting A Washing Programme - Electrolux ESL 4135 Instruction Book

Starting a washing programme

In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs
to be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off push button
The On/Off indicator light comes on.
4. Setting and starting the programme
Press the push button corresponding to the required
programme (see "Washing programmes" chart).
The corresponding indicator light will flash.
If you want to change the programme, simply press the
push button of a another programme.
Close the dishwasher door, the programme will start
automatically. An audible signal advises you that the
programme has started.
The indicator light of the programme under way is now
permanently on.
5. Interrupting or cancelling a washing
programme
Interrupt or cancel a washing programme in progress
ONLY if it's absolutely necessary
To interrupt a washing programme
Attention! Hot steam may escape when the door is
opened. There is risk of scalding. Open the door
carefully.
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the
point in which it was interrupted.
To cancel a washing programme
Open the dishwasher door.
Press the push button corresponding to the running
programme for about 1 second, until the indicator light of
the running programme turns off, indicating that the
running programme has been cancelled and that the
machine has returned to setting mode.
It is now possible to select and start a new washing
programme.
6. End of the washing programme
The dishwasher will automatically stop and an
intermittent audible signal informs you of the end of the
washing programme.
The end of programme indicator light starts flashing.
The On/Off indicator light remains on until the On/Off
push button is depressed.
Wait until the end of the audible signal before opening
the door.
Hot steam may escape from the appliance when opening
the door immediately after the end of the programme,
therefore, open the door carefully.
Switch off the dishwasher by pressing the On/Off push
button.
Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Leave the dishes in the dishwasher for approx. 15
minutes, with the door ajar, after the end of programme
so that they dry better and will be cooler.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
11